help reading codes!!!
#1
Junior Member
Thread Starter
Join Date: Oct 2012
Location: scranton, pa
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Story time. Did a plugs, wires, air filter, oil tune up last week. Driving home my check engine light came on. 2 days later about 1/4 mile from my house my truck completly dies at a red light. Push it to the side of the road. Sits for a few then i crank the **** out of it and it fires up.
Because of this i replace coil pack, cap and rotor and the ignition control moduel.
Light is still no and hasnt died sence.
Today i did the ol paper clip trick and got the light to flash but i am having a hell of a time decoding it.
Can anyone help??
This is on a 93 f150 5.0 2 wheel drive with the 5 speed tranny
Because of this i replace coil pack, cap and rotor and the ignition control moduel.
Light is still no and hasnt died sence.
Today i did the ol paper clip trick and got the light to flash but i am having a hell of a time decoding it.
Can anyone help??
This is on a 93 f150 5.0 2 wheel drive with the 5 speed tranny
Last edited by carpenter eyes; 03-02-2013 at 03:34 PM.
#2
Member
#4
Member
Change the ECT sensor, disconnect the battery for no less than 15 mins then go test drive and see how it does.