Originally Posted by k.black
can you explain to me the install procedures
its very simple believe me i never wire anything and i took this one on and was suprised how easy it was..
step 1- lay out all your parts make sure you have an idea of where everything connects etc etc(idiot proof everything only connects to a specific connector)
step 2- remove headlights and install the new hid bulbs ( do not touch the glass parts with bare hands ruins the bulb)
step3- find a spot close to the headlights to mount the ballasts ( i took my time on this step and didnt drill any holes i looked around and found existing bolts to use)
step 4- run the harness ( i took my time to do it clean i ran it in front of the radiator and tucked the wires up under the plastic shroud only wire vissable is the power cable going to the battery)
step 5- once harness wires are run connect the ballast to the relay harness then you need to ground each side by cleaning a spot and drilling a hole to mount the grounds
step 6- now you are ready to hook the headlights up the hid bulb connects into the pigtails off the ballasts again the connections are self explanitory reinstall the remaining stock bulbs for the turn signals
oh i forgot to mention on one side there is a connection from the harness that connects into the old halogeyn bulb connector you have to connect that before putting headlights back in
step 7- finally connect your power wire to the battery and before actually bolting the headlights back in just put them inplace and turn on your new lights make sure everything is good and your good to go...
oh last but not least on the side you still have a stock headlight bulb hanging i took it out and wire taped the conector to keep it from moisture and what not
thats about it man