Oracle truck LED light bar
#1
Oracle truck LED light bar
I just recently purchased the Oracle extreme truck LED light bar for my 2010 F150 XLT and ran into a couple of issues.
1. The 4 pin adapter didn't work, when plugged in the white reverse lights acts as daytime running lights so that was wired wrong.
2. I disconnected the 4 pin adapter and hard wired straight to the trailer light harness.
The reverse, brake lights and running lights are working fine, but the turn signals doesn't work correctly.
The trailer harness has the same lines for L/stop, R/stop. When I use the turn signal the whole bar blinks instead of just one side.
If anyone has installed these lights before, please post the way you wired it. Or please post a wiring diagram to best wire this bar.
I'm new to this forum so if there is another thread with the same issue I apologize..
1. The 4 pin adapter didn't work, when plugged in the white reverse lights acts as daytime running lights so that was wired wrong.
2. I disconnected the 4 pin adapter and hard wired straight to the trailer light harness.
The reverse, brake lights and running lights are working fine, but the turn signals doesn't work correctly.
The trailer harness has the same lines for L/stop, R/stop. When I use the turn signal the whole bar blinks instead of just one side.
If anyone has installed these lights before, please post the way you wired it. Or please post a wiring diagram to best wire this bar.
I'm new to this forum so if there is another thread with the same issue I apologize..
#2
noob :)
I would check to make sure you have a good ground... the four pin connector might have fit to the main harness where the taillights connected...
Last edited by byte; 11-13-2013 at 03:40 PM.