Led light bar help
#11
F150 Forum
iTrader: (3)
Really good thread here, should give you a lot of ideas.
https://www.f150forum.com/f83/101-wa...xcrazy-262046/
https://www.f150forum.com/f83/101-wa...xcrazy-262046/
Last edited by Total Automotive Performance; 09-25-2014 at 06:34 PM.
#12
Member
The following users liked this post:
Total Automotive Performance (09-25-2014)
#13
F150 Forum
iTrader: (3)
^^ Such a clean truck.
Those who are thinking about buying some Rigid Industries lights soon, check out this killer special - Rigid Industries 1st Rebate Sale – Starts 10/1
Those who are thinking about buying some Rigid Industries lights soon, check out this killer special - Rigid Industries 1st Rebate Sale – Starts 10/1
The following users liked this post:
goneMINIcrazy (09-26-2014)
#14
#15
Member
I drilled through that back "winch plate" and mounted the Rigid mount tabs to that. Just requires a little bit of measuring, nothing crazy. You will need to remove those "bread boxes" on the sides of that opening during installation, but that's easy as they just pop off.
I'll find some pics for you later. YES it does help. Quite a lot.
I'll find some pics for you later. YES it does help. Quite a lot.
#17
Member
You're seeing the cheap chinese knock-off ones probably. If you buy a high quality domestic made one like Rigid Industries, they will come with a full premade easy-to-use wiring harness with switch.
#18
Member
A set of Duallys could definitely be spliced into the fog lights, but you wouldn't want to run a large bar off the fog wiring.
#19
I was looking at these to put in the grill 4 total
or these
Heres the 20" bar to put in the bottom
Im pretty sure I can cut off the end of this connector or either buy the correct end and put on the lights that dont have it.
or these
Heres the 20" bar to put in the bottom
Amazon.com: 120w Light Bar Led Cree 20" Spot Combo Work Off Road Fog Driving 4x4 Bumper Rock: Automotive
Im pretty sure I can cut off the end of this connector or either buy the correct end and put on the lights that dont have it.
Last edited by 13TuxEco; 09-27-2014 at 12:13 PM.
#20
Member
I'm not a fan of the Chinese knock-off lights but if you must...
Those cubes will work fine, but you'll still need wiring harnesses for them.
That bar is too big for the opening down there if you have an EcoBoost, it will block too much airflow to the lower intercooler. You will need to get one of the "Single Row" lights rather than the "Double Row" you selected. Like this one or similar:
Those cubes will work fine, but you'll still need wiring harnesses for them.
That bar is too big for the opening down there if you have an EcoBoost, it will block too much airflow to the lower intercooler. You will need to get one of the "Single Row" lights rather than the "Double Row" you selected. Like this one or similar: