Finished my retrofit
#1
Senior Member
Thread Starter
Finished my retrofit
Did these in about 8 hours. The 2014 housings opened up nice and easy, and the EVOX-R bolts right in. I wish I had ordered the 6" xBLed strips but oh well.
#6
Senior Member
Thread Starter
Drilling tiny holes in the shrouds for mounting the halos and strips with wire, but other than that - No. The old projector unbolts and the EVOX-R bolts right in. Alignment is a breeze lol.
Ordered the housings from TRS, so they were delivered without the bulb and ballast - so no before shots sadly.
I was running a blacked out set of FX-R retrofits, which I enjoyed but these look so much better. the CBI bulbs at 50w are something to write home about, I can tell you that.
Ordered the housings from TRS, so they were delivered without the bulb and ballast - so no before shots sadly.
I was running a blacked out set of FX-R retrofits, which I enjoyed but these look so much better. the CBI bulbs at 50w are something to write home about, I can tell you that.
#7
Official Bass Slapper
I've been wanting to do this to my lights and I like what you did with the LED strips. Is there enough room to do the 6 inch strips?Also, did you just reuse the shrouds? Because I kinda like the look of the oem shrouds but don't know if I can reuse as I've never done a retrofit.
Trending Topics
#8
One Clean Machine
iTrader: (5)
Nice work, agreed the 6 inch would fill the lines nicer, but good work!
#10
Senior Member
Thread Starter
I've been wanting to do this to my lights and I like what you did with the LED strips. Is there enough room to do the 6 inch strips?Also, did you just reuse the shrouds? Because I kinda like the look of the oem shrouds but don't know if I can reuse as I've never done a retrofit.
OEM shrouds go back on perfectly.
The following users liked this post:
Jeriko (10-20-2014)