20AWG in line fuse
#1
Master Member
Thread Starter
20AWG in line fuse
Anybody give me an idea where I can purchase 20AWG in line fuses? I have all my LED lights installed but now I need to run the power. Somebody told me I should fuse the leads.
But, where can I buy the 20AWG in line fuses? I am asking about 20awg cause that is what size wire comes out of my led's
Thanks in advance
But, where can I buy the 20AWG in line fuses? I am asking about 20awg cause that is what size wire comes out of my led's
Thanks in advance
#2
Anybody give me an idea where I can purchase 20AWG in line fuses? I have all my LED lights installed but now I need to run the power. Somebody told me I should fuse the leads.
But, where can I buy the 20AWG in line fuses? I am asking about 20awg cause that is what size wire comes out of my led's
Thanks in advance
But, where can I buy the 20AWG in line fuses? I am asking about 20awg cause that is what size wire comes out of my led's
Thanks in advance
Radio shack, parts express, Amazon.
#3
Senior Member
Just go to Orileys or Autozone, this is what you want, this one is sized to take a 30 amp fuse, you can go down in fuse size, just not over. http://www.oreillyauto.com/site/c/detail/LIT3/FHA2BP /N1177.oap?ck=Search_fuse+blocks+%26+holders_-1_-1&keyword=fuse+blocks+%26+holders
Last edited by seaeagle2; 03-24-2014 at 12:22 AM.
#4
Senior Member
Anybody give me an idea where I can purchase 20AWG in line fuses? I have all my LED lights installed but now I need to run the power. Somebody told me I should fuse the leads.
But, where can I buy the 20AWG in line fuses? I am asking about 20awg cause that is what size wire comes out of my led's
Thanks in advance
But, where can I buy the 20AWG in line fuses? I am asking about 20awg cause that is what size wire comes out of my led's
Thanks in advance
As long as the wire on the fuse holder is the same or larger than the leads coming from the lights you're good to go. Then you just need to figure out the fuse size. If you're just running some LED strips/accent lighting, etc. a 5A is most likely fine; but I'll need to hear back from you with a few more specifics before I can give a definite recommendation.
#5
Master Member
Thread Starter
Lights, on 1 section I have approximately 10' , 1 section I have approximately 5' and the last section I have approximately 4 '. All strip lights.
Draw..... I have no idea.
I do know the wire that is used is 20 AWG, so I thought that was the important part.
Thanks for,the help
Draw..... I have no idea.
I do know the wire that is used is 20 AWG, so I thought that was the important part.
Thanks for,the help
#6
Senior Member
Lights, on 1 section I have approximately 10' , 1 section I have approximately 5' and the last section I have approximately 4 '. All strip lights.
Draw..... I have no idea.
I do know the wire that is used is 20 AWG, so I thought that was the important part.
Thanks for,the help
Draw..... I have no idea.
I do know the wire that is used is 20 AWG, so I thought that was the important part.
Thanks for,the help