5.0 Towing help?!?!?!?
#13
DOC 14 SCrew
Thread Starter
Join Date: Dec 2014
Location: Yuma AZ
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
So not in any way am I questioning any of yall on here as you all have used these trucks for everything......with that being said......why are the dealer and the factory customer service guy I talked to telling me my truck is rated at 9700k# when with the gears I have it's only rated at 7700k# for towing?
Thanks yall for everything. It's been a huge help and worry off my mind.
Thanks yall for everything. It's been a huge help and worry off my mind.
#14
So not in any way am I questioning any of yall on here as you all have used these trucks for everything......with that being said......why are the dealer and the factory customer service guy I talked to telling me my truck is rated at 9700k# when with the gears I have it's only rated at 7700k# for towing?
Thanks yall for everything. It's been a huge help and worry off my mind.
Thanks yall for everything. It's been a huge help and worry off my mind.
#15
Not sure why unless the numbers in the guide are wrong, which would make us all very happy. Even at 7700 you should still be ok right at max or a hair over but within reason. Take your time position the load right and use a good hitch. I tow with my very similar weight truck(super cab but longer bed) with a 7500lb and sometimes a bit more gn trailer in those very same hills and it does a fine job. You won't be holding up traffic just tow it and let the truck do its job. I lock out 6th in the hills but other than that just use tow haul and go
#18
DOC 14 SCrew
Thread Starter
Join Date: Dec 2014
Location: Yuma AZ
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
I have a column shifter and I know what your talking about. What does that do for me? Forgive my ignorance on the subject. Just had my trailer brake controller put in yesterday so I should be good now. I'll take pics and post them fully weighted down before I get on the road. Thanks again gents.
#19
DOC 14 SCrew
Thread Starter
Join Date: Dec 2014
Location: Yuma AZ
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
2014 KR. I have the RCI full skid pack on my truck and it's bad ***. So you know. 10g steel is solid and all the plates were super easy to put on. I recommend a lift though. It would have been easier if I had a lift.
#20
Push the tow haul button on your shifter and click the minus button on there one time and you will see only gears up to 5 lit up,click twice and only up to 4 and so on. It will shift normally up to the gear you have set as the top gear.