BrowningSCrew

I used the original wires, put connectors on them, and hooked them to an LED indicator light from orielys. I had to drill a new hole in the back of the cupholder to get it to fit. There's only two wires in there so you'll get it within 2 try's.

BrowningSCrew

Photoshopped a Max-4 camo stripe on it earlier and I think it's pretty mean, may be a possibility in the future



Better design

BrowningSCrew

Here's the wiring diagram I used. It wouldn't let me send this through PM

99Longhorn

thanks. thats helpfull. usually i can just figure it out, but its qucikr when you do it right the first time. and ill post up some pics when i get around to doin mine

BrowningSCrew

That's for my fogs. I didn't use a relay for the cupholder light it's just hooked to the factory cupholder light wires. I'll get you a pic of the light I used. Both of the factory wires are black so you can't tell + from - so I just cut the OEM light off, put female connectors on both ends and tried it till it worked.

BrowningSCrew

Here's the light I used. You will have to drill out a bigger hole in the back of the cupholder so it will fit and open and close right.

99Longhorn

Oh haha. Where did you get the light?

BrowningSCrew

O'reillys or autozone has them too

Neff150

Looks sharp man! Was thinking about getting either Max-4 or the raptor decal, any input on that? Ive always loved the way that decal looks on the raptors

BrowningSCrew

Well since nobody makes the Max-4 yet you'll have to get the black raptor decal they sell on eBay and trim it to fit. Idk how much work that would take or how close it would be to fitting because I photoshopped those and had to massage them and tweak them to get them to fit the truck the way I want. I'm going to see about having that done within the next year or so after I get tires and different steps.