New 11G FX4 Owner from Ga
#12
Senior Member
Thread Starter
New goodies..
After a couple hours and a 6 pack I just finished the install. I have an XLT so what I did was buy some 16 gauge wire, one red for power and one black for ground. I combined the three red lights into a splice for one wire, then tapped into the corner light (the top one). I combined the three black wires into one and grounded it to the bracket that holds the horns I believe. I used Matte white plasti dip for the letters since I know they will get beat up anyways, I did not want to spend a lot of money or time on these. Not the cleanest job, but all in all they work and install was straight forward.
Before..
After...
After a couple hours and a 6 pack I just finished the install. I have an XLT so what I did was buy some 16 gauge wire, one red for power and one black for ground. I combined the three red lights into a splice for one wire, then tapped into the corner light (the top one). I combined the three black wires into one and grounded it to the bracket that holds the horns I believe. I used Matte white plasti dip for the letters since I know they will get beat up anyways, I did not want to spend a lot of money or time on these. Not the cleanest job, but all in all they work and install was straight forward.
Before..
After...
#14
Senior Member
Thread Starter