My Platinum Screw build
#371
Senior Member
#372
Senior Member
Thread Starter
I heated the oven to 225 and set a timer for 20 minutes, then worked them apart very slowly with a small flat head screw driver. Then once I had gem partially separated I threw them back in the oven for 5 minutes and pulled them the rest of the way apart.
#373
Senior Member
Thread Starter
Well [MENTION=124185]mattmark6[/MENTION] we will see what we can do for you haha
The following users liked this post:
jedeckert1984 (02-08-2014)
#375
Senior Member
#377
Judging by the sticker on your Yeti. I know exactly what rims you got. Nice Man. I'm a Team Member member too. Wish I got in on the pre-order while it was there, the A101B is my favorite wheel design by far. Although the ones I posted are pretty sick as well. Can't wait to see them installed.
Well, I gave up too much info. Sorry David.
Well, I gave up too much info. Sorry David.
Last edited by jedeckert1984; 02-09-2014 at 02:09 PM.
#379
Senior Member
Thread Starter
Well the cats out of the bag, I put a picture of my coolers to see if anyone would catch the sticker on my 65qt and [MENTION=135030]jedeckert1984[/MENTION] found it. I am going with 20x12 Anthem Offroad wheels. I am stuck between the gloss black and machined enforcer and the gloss black and machined defender, but I have until the end of march to make my official decision.
#380
Confused Member
Well the cats out of the bag, I put a picture of my coolers to see if anyone would catch the sticker on my 65qt and [MENTION=135030]jedeckert1984[/MENTION] found it. I am going with 20x12 Anthem Offroad wheels. I am stuck between the gloss black and machined enforcer and the gloss black and machined defender, but I have until the end of march to make my official decision.