IBF150 - 2005 F150 4x4 Build
#43
Senior Member
Thread Starter
Thanks yall. Good to meet you too Robert.
So I've been looking at my doors and I'm really not happy with them, It was my first time fiberglassing, doing body work etc and I've done a bit more of research since then. I'm picking up a new set of panels tomorrow for doors 2.0. This build is gonna be a pod that bolts onto the door instead of molding it onto the door itself. They will be wrapped in vinyl and will have a grille to go over the speakers. I'm excited to show off my new skills and tricks that I've learned.
So I've been looking at my doors and I'm really not happy with them, It was my first time fiberglassing, doing body work etc and I've done a bit more of research since then. I'm picking up a new set of panels tomorrow for doors 2.0. This build is gonna be a pod that bolts onto the door instead of molding it onto the door itself. They will be wrapped in vinyl and will have a grille to go over the speakers. I'm excited to show off my new skills and tricks that I've learned.
#45
Senior Member
Thread Starter
My love for bass has finally decided my backseat has to go. Currently waiting on RAMDesigns, I asked him to design me a halfwall for 4 15" Soundqubed HDS300s tuned at 33hz. Last we spoke it was gonna be a port on the center with 2 subs on each side. While I do love my bass, the truck is a show vehicle first so I'm sure there would be more ideal port locations as far as SPL goes but aesthetics are playing a big part on the design. This truck will probably never see a meter, but it will be enjoyed daily and will be demoed at shows.
So equipment list looks like
4 Soundcubed HDS300 15s
Taramps 5000.1 or a Banda 5000.1, leaning towards the Banda since it puts out about 6700w rms at 14.4v
5 Optima Yellow tops
270amp High output alternator
Lots of SHCA wire.
So equipment list looks like
4 Soundcubed HDS300 15s
Taramps 5000.1 or a Banda 5000.1, leaning towards the Banda since it puts out about 6700w rms at 14.4v
5 Optima Yellow tops
270amp High output alternator
Lots of SHCA wire.
#48
Dang. Cant wait to see some pics!
#49
Senior Member
Thread Starter
Thanks yall, I should have the design at some point this week. There's enough space for the HDC3.0s, actually if I decide to upgrade later the box will work with them. Hopefully it demos well.