Fun Daily Driver, with power! Affordable
#11
That's going to look really good! I'm thinking of doing something like that, but I'm scared of cutting into my bumper....
#12
Senior Member
Thread Starter
It's sketchy for sure but I just taped it off and measured 20 times. Cut once ha
It's not the straightest lines but the faceplate covers any imperfections.
#13
So all you have to do is drill the holes for the screws and cut out the shape of the cube right? And do you think there will be any problem with the cutouts rusting after a while?
#14
Senior Member
Thread Starter
Correct.
I drilled a hole in each corner where the light fits through so I could have a nice corner and get my saws all in there to start cutting. Then I laid up the mounting bracket and drilled the mounting holes.
To prevent rust I painted the exposed metal with a clear coat sealant and then used a silicon around where the light meets the bumper to help seal it that way too.
#18
Senior Member
Thread Starter
#20
Senior Member
Thread Starter
Reverse lights 2
I wish I could get the camera to focus... It's not blinding to the reverse camera just doesn't look right when i take a picture of the screen showing my backup camera view
I wish I could get the camera to focus... It's not blinding to the reverse camera just doesn't look right when i take a picture of the screen showing my backup camera view