4x91

Didnt like the xlt trim so i took it off




It left that all the way around

So i bought 3m's adhesive removal wheel and got a section off. Well that smudged the paint so i rubbing compounded it and then waxed the hell out of it. It looks fine now. Only got one section done (dont have a pic) and am gone for like 3 weeks.

4x91

I need to wax the whole truck again once i am done.

Also i bought and installed Bully aluminum side steps from RealTruck.com

4x91

nfldfordman

Looks so good

charles nix

Very sexy-- ,love the tie downs. I use some for a big portable air compressor, like the Diesel Tire trucks use. Yes big!

4x91

I am almost done with the drivers side removing the adhesive. It should have been done long ago, but i have been away from it quite frequently, and my battery drill sucks . I would use my corded drill but its is an 1/8 of an inch too small to recieve the wheel.

4x91

Also i bought a flag




And some pvc




(1&1/2 in diameter)

I am going to drill the pvc into the inside of the bed tomorrow. I was going to do it today, but it rained on me. There are better ways to rig this thing, but this is the cheapest

4x91

To come:
Mount flag
Finish removal of xlt trim adhesive
Add ZMax (i made another thread for that)
Wash and wax entire truck again
Get some sort of bedliner
Make cupholder

4x91

4x91

i put a screw all the way through at the bottom, drilled wider at the top then put another at the top through the back only