2thousand5.4's build
#231
Senior Member
Thread Starter
Picked up a set of forged weld Cheyennes in 18x10 the other week but they were pretty rough. So far I got this one done. I think it came out good. I have a pretty solid lead on a PIAA valance too. Hopefully I can get that and get these welds on in the next month.
#233
Senior Member
Thread Starter
Well the bad news is one of the welds cracked and is toast, also they are next to impossible to find. The good news is a got some raceline renegades to replace them. They look almost identical, they are just 8.5 wide and 0 offset :/. Spacers help with that tho. I ended up getting the piaa valance too it just needs to be repainting. My brakes suck so I have an expedition swap on the way. I also scored on Craigslist again Yesterday. I got a full set of brand new in the box Fox 2.0s for 225. They retail for 130 a piece. Brake parts should be here by Friday. After that's all done I gotta rebuild my steering
Last edited by 2thousand5.4; 03-29-2017 at 09:40 AM.
#234
Senior Member
Thread Starter
I finally got some go fast parts. Built 4r70w with 7 plate clutches, billet 2400 stall torque converter and I'm buying Idb2328s long block with the lightning setup. The engine has a forged crank, Manley rods and pistons, ARP hardware, 9.6:1 CR, Trick flow 38cc heads, stock cams, and they m112 pullyed at 12 psi. I'll probably port the blower before everything go in my truck. I'm picking it all up in 2 weeks, I can't wait. This week I have a stock L heat exchanger, an Intercooler pump, L fuel hat with twin 255s, a fuel pressure regulator, and some new relay and fuse box's coming in. My plan is to have all that on and everything wired up before I pick the engine up.
#235
Senior Member
Any updates ? Hows it going ?
#236
Senior Member
Thread Starter
Engine is in, still waiting on the transmission. Transmission should be done this week tho. I have to have the truck running by the end of the month so it will be done soon. Old pictures but you get the idea. All I have left to do is mount the heat exchanger (which is huge compared to stock), finish up some wiring, and run the vacuum lines, and put the trans in. I also undercoated the truck while everything was apart
Last edited by 2thousand5.4; 06-20-2017 at 05:58 PM.