2011 Blue Flame Metallic FX4 Build - BC119
#93
Senior Member
Thread Starter
I had them wrapped gloss black and just pulled them because they were peeling. I was thinking about either finding matching not blue wrap or straight up sanding them down and painting them. I'll do them again when I do the side emblems.
#94
Senior Member
Thread Starter
#96
Senior Member
Thread Starter
#97
Senior Member
I like your stance as well but I like to keep my truck clean so if I had that much offset throwing rocks and mud and salt on the paint I would get some fenders. Then raptor steps but that's me!
The following users liked this post:
BC119 (06-24-2016)
#98
Senior Member
Thread Starter
I recently picked up a set of custom vinyl wrapped emblems from Moody Blue and I think they came out absolutely killer.
I also pulled off the satin black tailgate strip in preparation for putting the rear emblem on, because I knew I wouldn't be able to get the emblem off without breaking it once it went on.
Here is the completed tailgate.
Closeup of the emblems, I got satin black to match the color I used to paint the surround. They're usually done in matte black. In the sunlight you can easily distinguish the gloss Ford and the satin black background, but it's a little harder with overcast skies.
I also pulled off the satin black tailgate strip in preparation for putting the rear emblem on, because I knew I wouldn't be able to get the emblem off without breaking it once it went on.
Here is the completed tailgate.
Closeup of the emblems, I got satin black to match the color I used to paint the surround. They're usually done in matte black. In the sunlight you can easily distinguish the gloss Ford and the satin black background, but it's a little harder with overcast skies.
The following users liked this post:
BC119 (06-28-2016)
#100
Senior Member
Thread Starter
So I found out that these trucks let you hit the limiter in manual mode today. Sounds pretty good on the 2-3 shift at limiter. Ran hard put away wet.