2004 Ford F-150 Heritage Build
#43
Senior Member
Truck looks like she's handling it well
#44
Member
Thread Starter
#45
Senior Member
They scan handle some weight that's for sure
#47
Senior Member
Haha well better than a banged up one
#48
Member
Thread Starter
Well, something is going wrong with the motor now. Ever since I took it to the alignment shop, it started squeaking like the belt was bad. The serpentine belt is fine, so I didn't think much about it. Then it started making a really ugly sound like a bearing was going bad in the pullys. I was going to replace my idler pulls and tentioner arm pully, but I never got around to it because a bigger problem popped up. Something is now wrong with the fuel system. I was in the Taco Cabana drive through and when I switched into drive, my engine cut out. Now sometimes when I come to a stop and start to accelerate it goes down to low revs, and almost dies. I don't know what's up, but I'm going to take it to a mechanic over the weekend. I'm tired of messing with it. Lol
#49
Member
Thread Starter
Stopped by the mechanic and he can't squeeze me in until next Tuesday. Anyway, I've narrowed down the things I want to do to it in no particular order:
-Paint front fender and maybe get the scratches out depending on cost (First)
-Straighten out bumper
-Install 4wd front valance and tow hooks
-Either a Daystar leveling kit or a spindle lift.
-Light mounting bar and 4 LED cubes on front bumper
-LED Fogs
-Led bar attached to headache rack to shine in bed.
-Rip out bench and install a split bench
-New Headlight lenses
-Raptor Grille Lights
-CAI
-Plastidip Badges and bumpers
-New antenna
I'm sure there are some other things I'm going to do, but I cant think of them right now.
-Paint front fender and maybe get the scratches out depending on cost (First)
-Straighten out bumper
-Install 4wd front valance and tow hooks
-Either a Daystar leveling kit or a spindle lift.
-Light mounting bar and 4 LED cubes on front bumper
-LED Fogs
-Led bar attached to headache rack to shine in bed.
-Rip out bench and install a split bench
-New Headlight lenses
-Raptor Grille Lights
-CAI
-Plastidip Badges and bumpers
-New antenna
I'm sure there are some other things I'm going to do, but I cant think of them right now.
#50
Member
Thread Starter
Truck still hasn't gone into the mechanic. I'm going to drop it off sometime this week. I hope it's not too expensive. If it is, I may be truck shopping again.