Key and keyless entry programing
#1
Your Boy Blue
Thread Starter
Key and keyless entry programing
Have been apart of a thread that has been having one hell of a time programming their key. This is exactly how I got my 2005 programmed. (sorry no pics. I didn't think I'd do this.)
Remote:
-Insert key into ignition.
-Turn key off to run 8 times within 10 seconds ending on run.
-This will enter your truck into programming mode. Doors locking will confirm programming mode.
-Within 20 seconds press a button on the remote needing to be programmed. Locks again will cycle to confirm.
-If you have more than one, repeat the last step. -Turn key to off position to clear programming mode and you should be good to go! (scobar said it first, extra-partss confirmed)
Chip:
-You need 2 key with chips already programmed.
-Insert one key on for 3 seconds, then off.
-Insert the 2nd key and turn it on for 3 seconds then off.
-With the new key, within 20 seconds, insert the key and start. Your key should be programmed. -Keys can also be programmed using diagnostic equipment.
That's the steps I had received from extra-partss from eBay. Awesome communication! Also, where I or my key for $23.99 with free shipping.
A1 locksmith cut my key, for free I might add too!
I did have to take my key apart to fit it in their machine. There were 3 screws. 2 lower and one under my "ford" sticker. There are a few parts make sure you don't lose! Wind the spring when you put it back together!
I did have to cut a chunk out of my ignition cover. Not to bad though.
Hope this helps!
Joe.
Remote:
-Insert key into ignition.
-Turn key off to run 8 times within 10 seconds ending on run.
-This will enter your truck into programming mode. Doors locking will confirm programming mode.
-Within 20 seconds press a button on the remote needing to be programmed. Locks again will cycle to confirm.
-If you have more than one, repeat the last step. -Turn key to off position to clear programming mode and you should be good to go! (scobar said it first, extra-partss confirmed)
Chip:
-You need 2 key with chips already programmed.
-Insert one key on for 3 seconds, then off.
-Insert the 2nd key and turn it on for 3 seconds then off.
-With the new key, within 20 seconds, insert the key and start. Your key should be programmed. -Keys can also be programmed using diagnostic equipment.
That's the steps I had received from extra-partss from eBay. Awesome communication! Also, where I or my key for $23.99 with free shipping.
A1 locksmith cut my key, for free I might add too!
I did have to take my key apart to fit it in their machine. There were 3 screws. 2 lower and one under my "ford" sticker. There are a few parts make sure you don't lose! Wind the spring when you put it back together!
I did have to cut a chunk out of my ignition cover. Not to bad though.
Hope this helps!
Joe.
#7
Member