Stainless Works Catback Video for Ecoboost
12-16-2012, 12:30 PM
#1
Senior Member
Thread Starter
Stainless Works Catback Video for Ecoboost
Here is Stainless Works Cat back setup for the Ecoboost. This is their chambered muffler option. I went this way because I was looking for a little more sound, but not being overly obnoxious.
This system delivers that. At start up you hear a nice rumble. On the road, it is very behaved. At 30-40 mph it is there for you to hear. At road speed 50 or above it is a slight hum. Nail the throttle at any speed and you get nice feedback from it.
The install is VERY easy. I was able to remove my stock exhaust without cutting it. The new system comes with a doughnut that's placed on the flange mating to the stock down pipe. There are hangers that go in the stock location on the muffler, and pipe that goes over the axle. I hung all the pieces, then tightened it down. It went very fast, no cutting was required on it as I have a long box and SC. If you have other combos the directions tell you how much to trim to make it fit.
The only thing to go wrong was I had both nuts lock up on the bolts that mount the flange to stock down pipes. Maybe some oil on the threads would have helped this.
Overall I really like it, here are some pics
This system delivers that. At start up you hear a nice rumble. On the road, it is very behaved. At 30-40 mph it is there for you to hear. At road speed 50 or above it is a slight hum. Nail the throttle at any speed and you get nice feedback from it.
The install is VERY easy. I was able to remove my stock exhaust without cutting it. The new system comes with a doughnut that's placed on the flange mating to the stock down pipe. There are hangers that go in the stock location on the muffler, and pipe that goes over the axle. I hung all the pieces, then tightened it down. It went very fast, no cutting was required on it as I have a long box and SC. If you have other combos the directions tell you how much to trim to make it fit.
The only thing to go wrong was I had both nuts lock up on the bolts that mount the flange to stock down pipes. Maybe some oil on the threads would have helped this.
Overall I really like it, here are some pics
12-16-2012, 02:44 PM
#3
Senior Member
Thread Starter
I have a clip if someone wants to post it, not sure how to do that. PM me an email address.
Drone is very minimal, if you can even call it that. You get an exhaust note that fades as rpms go up. I tried making a video and you can barely hear it at cruising speed. This was with an iPhone, don't have a camcorder.
Drone is very minimal, if you can even call it that. You get an exhaust note that fades as rpms go up. I tried making a video and you can barely hear it at cruising speed. This was with an iPhone, don't have a camcorder.
Last edited by Bender; 12-16-2012 at 03:17 PM.
12-16-2012, 03:12 PM
#5
Senior Member
Thread Starter
Email it to me at Sogwap55@yahoo.com and I'll post it up to my youtube and link it here....
Glad you like the setup man!
Glad you like the setup man!
The following 3 users liked this post by Franchi Motorsports:
12-16-2012, 03:40 PM
#7
Senior Member
Thread Starter
Trending Topics
12-16-2012, 03:50 PM
#9
Senior Member
Thread Starter