5.0 Quarter mile times and mods!
The following users liked this post:
da vette guy (12-02-2014)
#105
#106
Member
Made my way to Gimli Interlake drag way for the season opener and had some better than last year results.
15.298@92.01mph,scross86 stock fx2 screw, 3.73's and 20" alloys
60': 2.323
330': 6.4629
594': 9.2711
1/8th: 9.8991
Mph: 71.66
1000': 12.8399
1/4: 15.298
mph: 92.01
Much less head wind than last years time and somewhat better density altitude. Plan for next trip is take off some weight and add traction bars
15.298@92.01mph,scross86 stock fx2 screw, 3.73's and 20" alloys
60': 2.323
330': 6.4629
594': 9.2711
1/8th: 9.8991
Mph: 71.66
1000': 12.8399
1/4: 15.298
mph: 92.01
Much less head wind than last years time and somewhat better density altitude. Plan for next trip is take off some weight and add traction bars
#108
Senior Member
Because of the 20"FX wheels. The speedometer wasn't calibrated for them. So I ran faster than the speedo would tell the ECU. They are 1.5" taller. Although my truck didn't shut off until 100mph. So I'm not sure. About the speed limiter being the same on each truck.
#110
HOPEFUL
iTrader: (1)
14.62@95.46 MPETE 2012 RCSB STX 2WD 3.31 open, stock tune, stock 18" michelins. K&N drop in, exhaust dumped after resonator.
I HIGHLY doubt the K&N or dumped exhaust really helped anything. but I listed them anyway.
I HIGHLY doubt the K&N or dumped exhaust really helped anything. but I listed them anyway.
Last edited by MPETE; 05-20-2013 at 10:51 AM.