Need help/advise with torsion bars
#1
Need help/advise with torsion bars
Hi guys I'm new here and had a question about my truck. I got 2000 f150 2wd on 285/75/16's and I just had it leveled with a 2.5 inch leveling kit and a 3 inch body lift but I was going with a leveled look but I'm kinda leaning to the bully lean or front sitting higher. Can I still crank the torsion bars up without damaging anything like the stearing column or anything? Or should i just lower the rear. Want a second opinion before doing anything. Thanks guys. I can post pictures if yall need some. Also after them tires bald or find a good trade I'm going to get 35's so maybe leave it. I'm not sure yet just want some expert opinions thanks.
Last edited by shawn_Dobry; 04-11-2015 at 12:48 PM.
#5
What type of leveling kit did you install?
The 97 - 2004 'Heritage' model 2wd used springs up front while the 4wd used torsion bars. This is because of how the front axle connected with the wheel hub.
I too would like to see a picture and point out what bolt you were tightening.
Mickey
The 97 - 2004 'Heritage' model 2wd used springs up front while the 4wd used torsion bars. This is because of how the front axle connected with the wheel hub.
I too would like to see a picture and point out what bolt you were tightening.
Mickey