FORD F150 SMOKE LED 3RD BRAKE TAIL LIGHT Installation question
#14
Notorious Thread Editor
Here is the link to the ones I installed a bit ago. Quoted from the thread a few days back.
"Here are the tails I ordered..
http://www.gorecon.com/product.php?p...ord+F150+04-08
Here is the 3rd brake light...
http://www.gorecon.com/product.php?pk=85
They were both on sale and the discount code "4x4" helped even more. Like $120 more!"
"Here are the tails I ordered..
http://www.gorecon.com/product.php?p...ord+F150+04-08
Here is the 3rd brake light...
http://www.gorecon.com/product.php?pk=85
They were both on sale and the discount code "4x4" helped even more. Like $120 more!"
#15
Member
Thread Starter
Join Date: Oct 2008
Location: Cypress, TX
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
3rd brake light shortcut
http://store.racer-union.com/Shop/Co...2580/SFV/32388
I just bought the tail lights that SINCITYFX installed. If I had know about that password I would have bought all three from RECON.
I just bought the tail lights that SINCITYFX installed. If I had know about that password I would have bought all three from RECON.
#16
I just experienced the same problem trying to install the light today. Thanks for the post! I will try again tonight.
I noticed that there is not much of a rubber seal around the Recon light. Do you think moisture will get in around the outside of the housing?
I noticed that there is not much of a rubber seal around the Recon light. Do you think moisture will get in around the outside of the housing?
#17
Notorious Thread Editor
I put clear silicone in first.
#18
Just finished installing mine. What a pain in the butt!!
First, I had a hard time pushing in the white tab. Once I pressed in the tab, I was not able to pull the wire out enough to get to the plug. It just seemed that the wire was not long enough.
Finally I was able to disconnect the wire inside the hole and used my fingers to pull the plug through the other hole. This was a pain because I was at work and did not have needle nose pliers to help.
Oh well, at least it's done and it looks great.
First, I had a hard time pushing in the white tab. Once I pressed in the tab, I was not able to pull the wire out enough to get to the plug. It just seemed that the wire was not long enough.
Finally I was able to disconnect the wire inside the hole and used my fingers to pull the plug through the other hole. This was a pain because I was at work and did not have needle nose pliers to help.
Oh well, at least it's done and it looks great.
#20
Notorious Thread Editor
Just a heads up to all of you guys, I sealed mine and it still leaked today.
Take extra care. I am gonna use a homemade gasket and silicone this time.
Take extra care. I am gonna use a homemade gasket and silicone this time.