Does anyone know of a helper bag set up for 8 inch drop?
#11
Senior Member
rear is setup to lay with 33" tall tire (I have 32" --- 275/55/20)
I don't have any of the front, since I'm taking mesurement and still have an issue to resolve
should be able to lay full frame on 31" tire (in the next step, cause for now it will lay on the engine crossmember...1" lower then the frame)
I don't have any of the front, since I'm taking mesurement and still have an issue to resolve
should be able to lay full frame on 31" tire (in the next step, cause for now it will lay on the engine crossmember...1" lower then the frame)
Last edited by maxpat82; 02-17-2014 at 08:06 AM.
#12
rear is setup to lay with 33" tall tire (I have 32" --- 275/55/20)
I don't have any of the front, since I'm taking mesurement and still have an issue to resolve
should be able to lay full frame on 31" tire (in the next step, cause for now it will lay on the engine crossmember...1" lower then the frame)
I don't have any of the front, since I'm taking mesurement and still have an issue to resolve
should be able to lay full frame on 31" tire (in the next step, cause for now it will lay on the engine crossmember...1" lower then the frame)
#13
Senior Member
I'll do one when it's done or almost done.
now enough with poluting your thread...
at 8" you'll need to fabricate something, and notch quite a bit.
On my fx2: 8" would have made the axle tube at the same height as the frame.
If you want any travel: you'll need to notch about the same as me.
now enough with poluting your thread...
at 8" you'll need to fabricate something, and notch quite a bit.
On my fx2: 8" would have made the axle tube at the same height as the frame.
If you want any travel: you'll need to notch about the same as me.
Last edited by maxpat82; 02-20-2014 at 08:18 AM.
#14
I'll do one when it's done or almost done.
now enough with poluting your thread...
at 8" you'll need to fabricate something, and notch quite a bit.
On my fx2: 8" would have made the axle tube at the same height as the frame.
If you want any travel: you'll need to notch about the same as me.
now enough with poluting your thread...
at 8" you'll need to fabricate something, and notch quite a bit.
On my fx2: 8" would have made the axle tube at the same height as the frame.
If you want any travel: you'll need to notch about the same as me.