NORCAL SS

ive done the 3 inch on a few 2014 4wd. So far no axle issues and its been about 2 years

Bill Jones

Tony look at this pic and see what you think. You may remember me calling you about my belltech install where front only dropped 2 inches on my 2015 xlt

NORCAL SS

what about it?

Bill Jones

Does it look like the front is as low as it should be? I ordered another set of belltech shackles and cut an inch out of them and installed them. Also have a set of air shocks on truck with 50 psi in them to make it sit level.

NORCAL SS

2wd?

Bill Jones

Yes

neonbobo

does anyone know if I get beltech lowering struts for the the front and just do a 2 inch drop shackle in the back am I gonna have the carrier bearing problem or drives shaft vibration that everyone is talking about when they do a lowering kit? I only plan on doing a 2" drop in the front....any input?

Jeremycrlucas

2016
2wd
2/4 or 3/5
1,000
Doesn't matter

I am looking to lower my 2016 F150 to either a 2/4 or a 3/5 drop from belltech. The tires I am wanting to run on are 295 / 35 / 20, will all of this work or will I have to do any modifications to the inner fenders to prevent rubbing? Or, what are some recommendations for the drop and tire size. I am going for a street and show truck. I will be lowering the truck as well as wheels and tires, aftermarket Grill and skirts, along with performance adders
like the Boss 302 intake manifold, larger throttle body, custom tune, and possibly boosting it. Once I get a list going I will start a topic in the building thread for y'all to monitor and watch. I am just needing to get a good starting point which I figured would be the drop and wheels first

NORCAL SS

Please measure your truck ground to fender lip then I can Dualit in and give you full info

jsdecorte

1) 2016
2) 4wd
3) 3/5 or 2/4
4) under 1000
5) both doesn't matter.

i'm looking for a setup that will clear a 33" tire. 285/70/17 i think