Air-Lift SlamAIR bags Installed on Belltech 3/5 2012 FX2
#51
Senior Member
Got around to putting on my Slam Air kit 59210.
So far I'm really diggin the kit. Rides much better.
No bottoming out and now it sits perfectly level.
Before (belltech flip):
Attachment 166998
After with brackets and bags installed:
Attachment 166999
In air with pressure:
Attachment 167000
At ride hight with pressure:
Attachment 167001
I made a bracket and put the fill valves under the hitch:
Attachment 167002
Perfectly Level, 18" ride height all the way around
Attachment 167003
So far I'm really diggin the kit. Rides much better.
No bottoming out and now it sits perfectly level.
Before (belltech flip):
Attachment 166998
After with brackets and bags installed:
Attachment 166999
In air with pressure:
Attachment 167000
At ride hight with pressure:
Attachment 167001
I made a bracket and put the fill valves under the hitch:
Attachment 167002
Perfectly Level, 18" ride height all the way around
Attachment 167003
going to be getting the same kit as op. I have the djm 3 / 5 drop. I want the bags rear of axle on the leaf. Eric is talking about the ones that mount right about the axle where the leaf alignment pins are right? Different or same kit with two mounting locations?
#52
Senior Member
Same kit. you have to drop the axle and pull the pins to add a spacer to put in the lower L bracket so it lines up ok. I'm trying to figure out if I will have enough alignment pin head to put in a 4* shim
#53
Senior Member
I have these sitting in my garage, should have them installed with my flip kit next month
#54
Senior Member
I only have one alignment pin with the djm flip kit. This is the slam air kit? Any way or kit that doesn't have to mess with axle pins?
#56
Senior Member
I had a djm flip and slam air before.
#57
Senior Member
Just ordered this kit! Can't wait to get it installed!
So that alignment pin comes out and gets a spacer then goes right back in reversed with djm? Thx.
How hard was it to get the custom ride hight and bag placement for drilling holes?
So that alignment pin comes out and gets a spacer then goes right back in reversed with djm? Thx.
How hard was it to get the custom ride hight and bag placement for drilling holes?
#58
Senior Member
bag placement: it come with a alignment tube. (you'll underdstand when you'll see it and read the instruction)
custom height: if you know you to use a tape mesure, you should be good
custom height: if you know you to use a tape mesure, you should be good
#59
Let me know if you have any questions once you receive the kit.
#60
Senior Member
Started this install today. Got the bracket and spacers installed, setup the alignment tube and it seems very angled. Center of hub to fender at ride height is 19". The alignment tube nuts are all the way up and if you look hard the lower left bolt hole is not on the frame. Is it supposed to be this angled?? Mcgaughy 4" flip in rear.