2012 fx2 super crew install djm 4" flip HELP!!!!
#1
2012 fx2 super crew install djm 4" flip HELP!!!!
A friend and I just installed djm 4" flip for my 2012 f150 and I have a question ... I installed it and the frame does not seem to e even on both sides and the brackets seem to rest differently on each side and the bolts were too short, how do u usually correct all this when u install it, and how do u adjust the axle to center in the wheel well ? Anyone have similar problems ? Also how is the pinion angle adjusted ?
*
*
#3
Member
A friend and I just installed djm 4" flip for my 2012 f150 and I have a question ... I installed it and the frame does not seem to e even on both sides and the brackets seem to rest differently on each side and the bolts were too short, how do u usually correct all this when u install it, and how do u adjust the axle to center in the wheel well ? Anyone have similar problems ? Also how is the pinion angle adjusted ?
*
*
#5
You don't have a bracket on correctly. It is as simple as that. Maybe the alignment pin isn't seated properly on one side. I would loosen everything and double check it.
The other possability is one of the brackets got bent in shipping?
Dog tracking won't have any issue on tire wear so that isn't a concern.
The other possability is one of the brackets got bent in shipping?
Dog tracking won't have any issue on tire wear so that isn't a concern.
#6
Senior Member
Looks like the front hangers are to far forward. Toward the front of the truck. Notice how the front leaf spring bolt doesnt line up with where it was mounted on before.
Last edited by Spadey; 12-31-2012 at 01:12 PM.
#8
Senior Member