Wiring In Under Dash LED's
#11
Super Moderator
Thank ya much. I had kind of a dinosaur way of powering it up, and I've wanted to switch to that. And one more piece of advice about the boot from the door to the cab. That passenger side is easy. take you a few minutes to do. The driver side.... not nearly as easy. Took me 2-3 hours and I screwed up my finger. So glad I don't have to do it again...
#12
Senior Member
Thread Starter
iTrader: (1)
Thank ya much. I had kind of a dinosaur way of powering it up, and I've wanted to switch to that. And one more piece of advice about the boot from the door to the cab. That passenger side is easy. take you a few minutes to do. The driver side.... not nearly as easy. Took me 2-3 hours and I screwed up my finger. So glad I don't have to do it again...
#13
Super Moderator
Its annoying because you have nearly no room. I had to wedge my finger in the backside of the boot and barely hook the loop of wire I made so I could drag it through. very very tight gap, and just a total PITA.
#14
Senior Member
Thread Starter
iTrader: (1)
All wired up and they look pretty good. Works just how I wanted it to. Ill get a pic or two when it gets dark.
#15
Senior Member
Thread Starter
iTrader: (1)
Turned out nicely.
#18
Senior Member
Thread Starter
iTrader: (1)
#19
With your setup do the floor board lights also come on when your turn the interior lights on with the doors closed? I'm getting ready to do this and want them to come on anytime the interior lights are on.
#20
Senior Member
Thread Starter
iTrader: (1)
As long as you mean turning them on with the dimmer switch then yes. The map lights up top are independent.
The following users liked this post:
Del1650 (09-18-2014)