What did you do to your 10th gen today?
Senior Member
Had a slight shudder between gears so today I ran a trans cleaner through it, drove it, went through all the gears a couple times, dropped the pan which didn't have the notorious plunger in it meaning it's been changed before I got it 5 years ago, I was amazed there was absolute zero build up and no metal partials, the pan was damn near spotless, changed the filter and reused the ford gasket, flushed the TQ via the supply line in the front and ended up going through almost 12 qts of ATF before the fluid got ruby red, runs and shifts like a dream and no more shudder, seems like I caught it before it got bad. the whole process including drinking a few beers took 2 hours but could have been done in 30mins if I was in a rush I suppose.
Usually end up with a 4 hour job, LOL
Senior Member
Not just today but the last few. Put on my Hearthrob dual exhaust. 3" in and 2X2.5 out. Sound pretty good without being too loud. Took out the spare to install and decided not to put it back under with all the rusted parts. Built a mount for the bed, works great.
Senior Member
Originally Posted by jprevat
What brand did you use? I dont need the brand name but I want it to last.
Senior Member
iTrader: (1)
Senior Member
Originally Posted by jprevat
That is exactly the one I was looking at.
The following users liked this post:
pfoley12 (11-27-2015)
Senior Member
iTrader: (1)
It looks like pretty good quality, better than the cheap eBay ones I've seen people run. Light out put is pretty dang good.... (For those about to condem me) I know I know it's not rigid it's not as good it doesn't throw light as far... But honestly who cares, it puts out a ton of light was only $70 bucks and who the hell has $1500 to drop on a light bar for a daily driver lol if I need to I'll retrofit eventually
Senior Member
iTrader: (1)
Originally Posted by Collin
Cleaned up the sterling and frame. Mocked up the axle. looks like I'm gonna have a wheelbase of 122" and a 36" "bed" once i get the tank mounted
Senior Member
I have an rough plan. Planning on a little flat deck with some "fenders" outboard of the frame. II have a couple different ideas on how to do said fenders just gotta draw it on paper.
I'll take a picture geez
I'll take a picture geez