When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I welded the little tabs to the pipe and then welded the bottom of an exhaust clamp to the pipe and then welded it onto the tip. I promise you it's not going anywhere.
Should put bolts in the gap and used that as a filler
Should put bolts in the gap and used that as a filler
That would've been a good idea. I just looked down saw the clamp and stuck it on there and welded it up cause I was in a hurry lol. Damn bolts would've worked better though.
finally got my replacement door handle with the keyless entry keypad built into it. Time to find the connector hiding someone in the door and swap the locks and i'll be good to go.
Got my truck back after 300 dollar wheel bearing lol. Big thanks to Rutts auto if any of you guys are on here, I had a bad squeal coming out of the tire, they said bring it on over with out any appointment got the truck ready to go this morning.
I also got my skid plate back from powder coating and it looks great.
Got my truck back after 300 dollar wheel bearing lol. Big thanks to Rutts auto if any of you guys are on here, I had a bad squeal coming out of the tire, they said bring it on over with out any appointment got the truck ready to go this morning. I also got my skid plate back from powder coating and it looks great.
nice on the skid plate, what did that run you ? Might I ask. It looks great
Got a few better pics of the new exhaust setup. I'm really starting to like it. The bailing wire is just gonna be there until tomorrow or Friday and I'm welding hangers to it. I don't think it looks too big from behind either
Got a few better pics of the new exhaust setup. I'm really starting to like it. The bailing wire is just gonna be there until tomorrow or Friday and I'm welding hangers to it. I don't think it looks too big from behind either
03-25-2015, 01:21 PM
