What did you do to your 10th gen today?
Now an XLT in Colorado
Yesterday:
Modded the headlight switch for fogs on with lights at automatic and parking light positions, and replaced the backlight bulb inside, as well as bulbs in the HVAC panel and 4x4 switch.
Tonight's project:
Andy
Modded the headlight switch for fogs on with lights at automatic and parking light positions, and replaced the backlight bulb inside, as well as bulbs in the HVAC panel and 4x4 switch.
Tonight's project:
Andy
Now an XLT in Colorado
Senior Member
**** 82000 (or 72000 if power) Andy
Senior Member
The 72000 sure looks like what's on my truck.
Senior Member
When I put the 9000's on my 3/4 ton chevy. I got them for $74 each for it.
Pete
Senior Member
Going to tie the scope camera to a piece of PVC this weekend. Run it up from under the truck. And I bet I will find the nuts for them there. Bet they were hard to mount though as you had to start the nut with a 28" extension to get these on.
I thought at first I would be able to get to the nuts with the bed liner out of the way. But they bolt down where you can only get to them from underneath the truck .
Pete
I thought at first I would be able to get to the nuts with the bed liner out of the way. But they bolt down where you can only get to them from underneath the truck .
Pete
Senior Member
^ ^ Well that s()cks.
What do you guys think? So I swapped my pcm relay today with my fuel pump relay. But for those of you who don't know I have a hard start problem. Anyway when I did my theft light started blinking fast but when they were switched back it was fine, so my question is could one of my relays be bad? Also I have already put new fuel pump, IAC, cleaned the throttle body, cleaned maf sensor, and new air filter.
Now an XLT in Colorado
Hey bud, do you mind telling me how to change the 4x4 switch light bulb? I made a thread about it here, but no one responded. Appreciate it bud!
Andy