Show'em Off!!! Post up 97-03 trucks!
The following users liked this post:
nfldfordman (04-23-2014)
http://www.f150*****.com/
I just washed it real good with simple green then used a Scotch Brite pad to scuff it then got all the dust off and sprayed it with black VHT chassis paint.
Attachment 311898
Attachment 311899
Also sprayed the torsion bars with duplicolor stainless steel paint.
Attachment 311898
Attachment 311899
Also sprayed the torsion bars with duplicolor stainless steel paint.
http://www.f150*****.com/
Alright cool, thanks I was trying to decide to break out the wire wheel or not. That is is a really cool idea with the silver on the torsion bars, I saw that paint at the store yesterday but didn't know how to incorporate it, and if it would look good or not.
I'm doing my skid plate,bars and diffs with it. I think it'll look good,just to give you some other ideas. I bought a can but lost it some how lol.
Resident light whore
Only masked around the torsion bars when I went to paint them. And the wires and fuel lines on the drivers side. The rest I really didn't mess with.
Thanks it turned out cool. I'm going to eventually do my back axle black and do the diff cover silver to tie into the bars. I did the same on my highboy and it looked good too.
The following users liked this post:
larshell (04-25-2014)
If you have time, Removing the bed is a good idea. The spare tire braces and bed crossovers are notorious bad spots
Only masked around the torsion bars when I went to paint them. And the wires and fuel lines on the drivers side. The rest I really didn't mess with.
Thanks it turned out cool. I'm going to eventually do my back axle black and do the diff cover silver to tie into the bars. I did the same on my highboy and it looked good too.
Thanks it turned out cool. I'm going to eventually do my back axle black and do the diff cover silver to tie into the bars. I did the same on my highboy and it looked good too.