Rockford Amp Acting Funky
#1
Senior Member
Thread Starter
iTrader: (1)
Rockford Amp Acting Funky
So it is new in box and is the 250x1 and it is hooked to a 2 ohm Rockford 10. Problem is it doesnt play. It makes the sub move from high to low making a thud-thud noise continuously. When the RCA cables are unhooked the sub stops. The amp shows that it isnt in protect mode and I have it wired in the standard fashion without the use of high level inputs. Any ideas would be great because im stumped.
#2
Try another amp/sup setup if you can. That cut the possibilities in half.
#3
Senior Member
Thread Starter
iTrader: (1)
I dont have another at my disposal at the moment. I had the same sub and same wiring. in there on a boss amp and it worked like a charm... until the amp decided to cut off and never turn on again. Lol
Last edited by jprevat; 05-29-2014 at 09:08 PM.
#5
Senior Member
Thread Starter
iTrader: (1)
So trying a new set of rcas will be my best bet to find out whats going on? I had to buy a new set today so I was really hoping that wasnt the weak link.
#7
Senior Member
Thread Starter
iTrader: (1)
This is the amp I am trying to figure out.
http://www.rockfordfosgate.com/products/details/r250x1
Trending Topics
#8
Senior Member
Thread Starter
iTrader: (1)
Turns out the Rockford likes a better ground... straight to the frame and im happy as can be lol