ObsoleteE's 2001 Screw Lariat
Thread Starter
Senior Member
Joined: Nov 2011
Posts: 806
Likes: 22
From: Rochester, NY
Senior Member
Joined: Apr 2012
Posts: 2,137
Likes: 160
From: Garden City MI
Originally Posted by ObsoleteE
I picked up a spare with a brand new tire from a salvage yard for 32 bux, what a deal! This weekend I plan on adding a Magnaflow muffler, and Plasti dipping my flares and a couple inches of the bottom of the body.
Senior Member
Joined: Apr 2012
Posts: 2,137
Likes: 160
From: Garden City MI
Originally Posted by ObsoleteE
Just bought this, I can't wait to install it.
Nor-Cal
Joined: Feb 2011
Posts: 1,400
Likes: 61
From: Nor Cal CA
Thread Starter
Senior Member
Joined: Nov 2011
Posts: 806
Likes: 22
From: Rochester, NY
Originally Posted by jollyroger331
Be sure to post a vid of the way it sounds when your done. Looking to do my exhaust but I was thinking magnaflow. What did that kit run if you don't mind me asking, I haven't seen that one.
http://www.ebay.com/itm/97-01-FORD-F...076f91&vxp=mtr
My first choice was Magnaflow as well, but I couldn't pass this deal up. I'll be sure to post a vid.
Thread Starter
Senior Member
Joined: Nov 2011
Posts: 806
Likes: 22
From: Rochester, NY
Today I plasti dipped my fender flares, only one more plasti dip job and I'll be done.
11 years of dirt, not too bad.
All done
A little tip I would advise everyone to use when it's a bit chilly out is to put the spray cans into a cup of hot water for about 10 minutes right before spraying. It makes the plasti dip come out a lot smoother.
11 years of dirt, not too bad.
All done
A little tip I would advise everyone to use when it's a bit chilly out is to put the spray cans into a cup of hot water for about 10 minutes right before spraying. It makes the plasti dip come out a lot smoother.
