duanewalker76

I have just replaced my front rotors and pads, they were worn down beyond turning and they shook really bad when I would stop easy. Under harder braking they didn't shake. Well after replacement (which I assumed was going to stop the shaking) I still have the same problem. What could cause this? I have new brakes on the rear and just had a front end alignment and a balance and rotate.

GtRugby90

make sure you have enough brake fluid in your lines

NGM

Might have got some bad rotors.. It happens sometimes.

whitecrystal1

What rotors and pads did you get? Did you bed the pads to the rotors when you first drove the truck?

duanewalker76

fluid is fine, I checked it. I've never heard of bedding the pads to the rotars. What is that?

whitecrystal1

This should help...but long read

Good old Bill

Try this simple test. Stop vehicle with moderate to light pedal pressure. Steering wheel shake points towards front wheels. Again, try stopping vehicle using only parking brake. If you get a sensation that the wheels are egg shaped than your back brakes are the problem.

duanewalker76

O.K. it isn't the rear. I guess I'll remove the rotors and put a fine turning on them and see if that clears it up. I'll let yall know.