Exhaust ideas..
#11
Junior Member
Thread Starter
Join Date: Dec 2011
Location: Carthage, Mississippi
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
I went and got them put on today. The guy at the shop put them on today and told me that's he couldn't run true duals because the truck has an O2 sensor that would have to be cut out. Im not sure what I ended up with. It sounds good, but it's not as loud as I wanted. It was cheaper though. It cost me $283 for the setup.
#12
Senior Member
??? Where are you having the duals ran from? I have 2 sets of 02 sensors and duals ran just fine. The only time it matters is if your taking cats off. Which is really pointless. So...you don't know what setup you have?
#13
Senior Member
iTrader: (1)
I just had my system redone with a custom Y 2-2.5 into a 3" single all the way back and it was like 700-800 bucks with everything installed. for the 2.5 true duals it was like 900 all done but the guy said I may have problems with it throwing out codes. If you got it done for less than 300 what type of pipe did he use? You can have him put a new O2 bung in so it will still work.
Last edited by 03Scott; 12-16-2011 at 04:27 PM.
#14
I'm 16 and my dad gave me his 97 F150 5.4 4x4. I'm looking to put some pipes on it. I thought about putting true dual straight pipes with 3 inch tubing and 5 inch tips cut at a 45 degree angle. I was also considering having the rear two cats deleted. I was hoping someone could give me some insight on this. Any input would be greatly appreciated. Thanks.
#15
team ramrod
well i had a fancy exhaust setup with a flow 40, then i realized it wasnt loud at all, that cost me 350, i cut it all off and threw a $4 turn down and u bolt on my exhaust right where i cut my muffler off and i love it now... nice and clean lookin without tips hanging out the back.... IMO of course
#16
Originally Posted by 03Scott
I just had my system redone with a custom Y 2-2.5 into a 3" single all the way back and it was like 700-800 bucks with everything installed. for the 2.5 true duals it was like 900 all done but the guy said I may have problems with it throwing out codes. If you got it done for less than 300 what type of pipe did he use? You can have him put a new O2 bung in so it will still work.