Engine Builders talk.
#1331
Senior Member
Dble Post. Mann this site was chokin for a little bit there lol.
Last edited by Jbrew; 07-07-2014 at 04:37 PM. Reason: D- Post
#1333
Senior Member
#1335
Senior Member
#1337
Senior Member
Contaminate? Warping, - you just have to slow down , -take breaks. And/Or learn how to set up properly/ dial it in.
#1338
Senior Member
iTrader: (2)
Anything except 6xxx or 4xxx is nearly impossible for me to tig. I'm sure if I got good at it, it would look and hold much better I just don't have time.
Def not the welder, it's all on me. I not patient at all!
#1340
Senior Member
I've had professional welders help out and I still have issues. I can do everything but aluminum, it's a damn demon or something.
Anything except 6xxx or 4xxx is nearly impossible for me to tig. I'm sure if I got good at it, it would look and hold much better I just don't have time.
Def not the welder, it's all on me. I not patient at all!
Anything except 6xxx or 4xxx is nearly impossible for me to tig. I'm sure if I got good at it, it would look and hold much better I just don't have time.
Def not the welder, it's all on me. I not patient at all!
If any of that makes sense to yuh