Help with P0750 code
#1
Junior Member
Thread Starter
Join Date: Jul 2019
Location: Las Vegas, Nevada
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Help with P0750 code
I have a 97 F150 xlt with the 4r70w and right when i was getting home the overdrive light started flashing followed by a check engine light with the P0750 shift solenoid A code. The o/d light only flashes at idle-under 10mph once it goes past 10 mph it stops. I looked around the forums and saw this can be cause by dirty/low fluid so i decided to drop the pan. Found like two small pieces of metal and just cleaned everything up and put back. Might have been low because the drain pan i had was inaccurate and read 5 qts so i replaced the 5 qts, when i went to put the old fluid in the empty qts i only managed to fill up 3 and a half qts. I thought that wouldve fixed the problem but i erased the code and it still came back. After the flush ive only droven it like 2 miles and under 30 mph should i try driving it more to circulate the fluid or would this hurt it? What else should i try?
#2
Senior Member
Take a picture of the metal pieces and post them.
#3
Junior Member
Thread Starter
Join Date: Jul 2019
Location: Las Vegas, Nevada
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
#4
Senior Member
Does it drive and act the same as it did before you changed the fluid?
#5
Junior Member
Thread Starter
Join Date: Jul 2019
Location: Las Vegas, Nevada
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts