Need torque specs for rear glass
#2
Bleeds blue
Are you using the butyl rubber WindoWeld rope? IDK if there are specs but I’ll check. I just tightened mine in a crisscross pattern a little at a time until snug, using a 1/4” drive shorty ratchet.
The following 3 users liked this post by ProjectSHO89:
#4
Junior Member
I just tightened them by feel to about the same force as to take them off. Glass guy that I was working with wasn't worried about torque specs but keeping the glass flat is a must so work in a cross pattern like putting on a tire.
The following 2 users liked this post by littleluce 8288:
Johnny Paycheck (04-13-2021),
ncranchero (04-13-2021)