Viper 5904V Install - Need help
#1
Viper 5904V Install - Need help
I picked up a full Viper 5904V kit including the BDBALL module. All though I'm not 100% sure what the module actually does.
Does any one have a wiring diagram for the my truck or know where I can get it?
I have an 04' FX4
thanks for the help
If you've installed this system on your truck please tell me anything I may need to know.
Does any one have a wiring diagram for the my truck or know where I can get it?
I have an 04' FX4
thanks for the help
If you've installed this system on your truck please tell me anything I may need to know.
#2
Senior Member
The guys over at http://www.bulldogsecurity.com have I pretty good chart of all the wires, there color and locations you should need. The module is to by pass the data the truck reads from your key. Remote start is just a fancy way to hot wire your truck so you got to make it think is not being stolen. The manual you need to install the module is at http://www.xpresskit.com/DocumentDow...irmwareid=3275 good luck
#3
Thank you very much!!!
I'm i correct in the understanding that with the dball installed I don't need to hook up every wire for the system CPU? The dball will lock, unlock,start the motor?
I'm i correct in the understanding that with the dball installed I don't need to hook up every wire for the system CPU? The dball will lock, unlock,start the motor?
#4
Senior Member
No.. you will still have to manually tie into every thing for the remote starter. The module could do all that if our trucks supported it but they dont. all the module is going to be used for is to bypass the security so you dont have to leave a key in the truck.
#6
Senior Member
You will with the db-all but it cant control the truck. Just read the install manual. I glanced over it and it looks like its all there. Wire that just as it shows and then wire into the viper. The only wire that goes from if db-all and the viper is the ground when running. You will have to look at the viper manual to find out which wire it is. Then you will have to wire the remote starter into the ignition switch and into the door locks. Also if you want all the dome light control stuff and security then you will have to wire into the door switches.