Bluhorse

sounds like a rubbing or scapping noise when turning left. when in park I can turn the wheel all the way left and right no noise so im thinking its not the power steering. looked underneath didn't see anything abnormal but I haven't took the wheel off yet planning on doing that in about an hour or so. any comments appreciated

tritonbullet

Jack up the truck from the A arm and put your hands on either side of the wheel and shake back and forth and check for any play if there is none now put your hands at 12 and 6 and wiggle top to bottom like a push and pull affect. If there is no play congrats your front end is tight next thing to do is check your strut mount you can do that by barely jacking tire off ground and using a long pry bar underneath tire and prying up if you hear a clunk clunk your strut mount is bad trust me you'll hear a noise also a good way to check for lower ball joint play.

Bluhorse

thanks will do. also forgot to mention the noise is coming from the drivers side

tritonbullet

Check the front end the link pins. Control arm bushings. There are a lot of things there.

Bluhorse

Turns out it was the hub/wheel bearing.

RajunKajun59

Check the Brake dust cover on the inside of the brakes, mine did the to me once, right after the bearings were replaced. Only b=made a noise turning one direction.