Specifications: Torque: Head Bolts: F-150 2004
#2
Tighten in a crisscross pattern to 30 ft lbs then an additional 90*. Loosen all bolts 1 full turn. Tighten again to 30 ft lbs in a criss cross pattern then an additional 90* then finish up with another 90*. That will put you at 90 ft lbs which is spec. I have done this with every mod motor I have built and never had a head gasket fail even with 23lbs of boost.
#3
Stage 1: Tighten to 40 Nm (30 ft. lbs.).
Stage 2: Tighten an additional 90 degrees .
Stage 3: Tighten an additional 90 degrees .
The bolts are tightened from inside to out.
I can send you a picture if you pm me.
Stage 2: Tighten an additional 90 degrees .
Stage 3: Tighten an additional 90 degrees .
The bolts are tightened from inside to out.
I can send you a picture if you pm me.
The following users liked this post:
mike1067 (06-02-2022)