loganberry

it will work kauffman, you just remove the plastic shroud in the front door, and it is a 6.5 spot up front :P

NordicSpawn

Be careful.........I don't know which model you have and/or if the door panels are much different, but my experience a few days ago is this:
1. Pull top sections on the uprights
2. Below those are two hex head bolts, remove
3. Along the bottom edge is one hex head, remove
4. Pop out the insert under the door handle and remove the 2 hex heads there.
5. Use something plastic (my windows are electric) and pop off the section below the window switch and unhook the connector if you want.
6. Remove the one hex head bolt to the door frame.
7. Pry the panel off lifting upwards there are slots the panel slides down into sort of.

Hope this helps, cause I broke the black plastic support off under the window switch by not knowing it was there and got lucky being able to see why I had to lift the panel off.

kauffman21

i got the 2004 supercrew xlt. so thats 6.5 in the front and 6x8's in the back?

CTRAHAN18

u will have two screws under the the plactic door panel take out the screws and right where the power window is pop that out and ther is a bolt under there undo that and lift the whole door panal UP and that is how it is going to come off its not hard at all

loganberry

yes, 6.5 up front, 5x7/6x8 in the back, you can do 5x7/6x8 up front too u just move the factory shroud for the 6.5