Show me your pinstripes
#11
Senior Member
Thread Starter
Going to try to remove the "4x4" decal on the rear fender, and then come up with a custom graphic to replace it. I'll use an orange/White pinstripe about 3" below the body line the full length of the truck, and probably split the pinstripe around the front fender badge.
#12
Senior Member
Thread Starter
Bringing this back to the top. Spring is coming, time to clean up and do a little personalizing.
Looking at different locations on the sides and tailgate to run them.
Show me your Pinstripes!
Looking at different locations on the sides and tailgate to run them.
Show me your Pinstripes!
#13
Senior Member
Your id of splitting around the fender badge would look great. If the strip runs into the 4x4 decal you could allow it to stop at it or split it and have them meet and end at the back of it
|------|
-------| 4X4 |
-------|------|
rough idea.
|------|
-------| 4X4 |
-------|------|
rough idea.
#15
Senior Member
Thread Starter
Am planning on removing the "4x4" decal, and either something else, or no decal, just stripes