Reverse problems
#1
Senior Member
Thread Starter
Reverse problems
On my 04 f150 when I put it in reverse it acts like it's in neutral for 30 or so seconds and then it will kit in. What's the problem?
Also getting a p1000 code
Also getting a p1000 code
#2
Mark
iTrader: (1)
Low on fluid ?? when is the last time it was serviced ?? P1000 DTC means drive cycle not complete...did you have a programmer with a custom tune installed ??
#3
Senior Member
^ what he said, have you checked the fluid yet? Also, you can crawl underneath and see if the plastic grommet on the linkage to the transmission is chewed up or gone, that may cause it to take a couple of seconds to actually catch but 30 seconds sounds like low fluid. Good luck, let us know.
#5
Senior Member
Thread Starter
Just checked it and dang fluid is over the plastic marker on the end of the stick about an inch past the hot mark and I checked it when it was cold. So could over filled be the problem??
#6
Advanced Member
iTrader: (-1)
Too much oil and it flows slowly, meaning the fluid gets hot, but can't get pushed to the cooler fast enough.