Replaced wheel bearing/hub assembly now ABS light is on
#1
Senior Member
Thread Starter
Replaced wheel bearing/hub assembly now ABS light is on
Ok so yesterday I decided to go ahead and take the time to replace the wheel bearing/hub assembly on the passenger side of my 2005 F150 SCrew 5.4. The change went well, while I had everything off I went ahead and replaced the brake pads and rotors since they were shot. Immediately after the switch there were no issues, but now it's throwing an ABS light after driving it for a few miles. I checked the connection of the ABS sensor wire in the wheel well and it is fine and is not making a difference in the light being on or off...
Can anyone offer any suggestions as to what could be the problem? Has anyone run into this issue before?
Can anyone offer any suggestions as to what could be the problem? Has anyone run into this issue before?
#3
Senior Member
Thread Starter
The sensor itself was replaced as well...it came with the bearing/hub assembly. It plugged right into the female connection that the old sensor was plugged into.
#5
Senior Member
Thread Starter
Just to update - had my mechanic bring his Snap-On scanner over and run diagnostics on the ABS system. The sensor that came with the new bearing/hub assembly is faulty. Needless to say it will be going back to Autozone and I am buying a new one that is a bit higher quality. Read a few negative reviews about Duralast parts so I think I'll opt with a Wagner part this time.
#6
Senior Member
Join Date: Jun 2008
Location: Suburban Washington DC
Posts: 247
Likes: 0
Received 11 Likes
on
10 Posts
Don't know what you paid for that probably made in China Duralast part but I found the cheapest prices at http://www.autopartstomorrow.com/ for Motorcraft parts or name brand aftermarket parts.