colevig

Replaced the passenger side door without much hassle only cost me 900 bucks for a used fricken door. Wire harness was different from it being off a different year so I had to rewrite the new door with the old door harness which was a pain but not too bad. Now looking for a year door and not having much luck. Oh we'll a lot less noticeable now. Had left over camp wrap so I got that back in also.

colevig

Last Monday I went and got my exhaust done finally. We dropped the muffler and dialed it from where the pipe went into the muffler and ran it out behind my rear passenger tire flush with the body like the raptors come with.

It's loud as he'll at start up and acceleration around town but sounds very aggressive and sweet. It has a nice low rumble at highway speed though. I may install a magnaflow muffler or something to tone it down some.
We'll see how long until I get pulled over.

Threw in a couple pics of it soon work and all shined up. That lasted about 3 days this spring.

colevig

Went mudding a little bit yesterday (-: fresh wax job kept it cleaner than I wanted though ha

colevig

Project in the works will post pics soon

colevig

Ptm mirrors and handles. Goes to show ptm paint isn't the same tone

MHOWELL34

Your truck has me all teary eyed lol. Good job sir! Keep up the good work!

bennie87

I want to paint my door handles. How did you take them off? Do you have to remove the door panel?

colevig

Yes take door panel off handle is two nuts inside door and two bolts behind two plastic plugs on the side of the door then after getting them out I used a wedge on the inside part of the handle to keep the handles pulled out and primed painted and cleared them let dry and put back on

colevig

Washed her and did some spring cleaning spent an hour under the truck pulling mud and grass out from my mudding trip

colevig

So my amp quit working a while back so I just took the sub out. Today I was bored so I wanted to see why my amp quit. Found out I wasn't getting any power to the amp. Inline fuse was good. Pulled my trim apart and found a big pile of foamy blue stuff. The line got cut somehow and corroded the wire away completely to the pint there was no connection there. Fixed now. Just a heads up to be careful for.