ok after doing some research the following should not be reading at 99.2 percent,
Stft b1s2. 99.2
Stft b2s2. 99.2
unless im miss reading information, according to PID that is too lean, but i did read that the numbers could be at 99 until the cat and evap run through their drive cycle to give an accurate reading. could this be true? i have not gotten any codes showing that im running lean, just 6 misfire.
the cat and evap are still blinking on my scanner which means they have not completed yet. again this is all knowledge that i might be reading wrong. have really just started doing my own work on fuel injected engines.