No start after edge
#11
Senior Member
iTrader: (1)
No start after edge
Originally Posted by 07f350man
Update
Edge sent me a file to try and fix my truck. I went to my truck all was looking good till right at the end my ignition was on but I wasn't trying to start it and my truck just started turning over. So I quick shut the ignition off and it kept turning over for a couple seconds enough that I was able to jump out of the truck to run for a wrench to unhook the battery. So I called edge again they sent me a new file so they can read my programmer to see what's wrong. Now they are reviewing the file and will get back to me when they know something. 🙏
Edge sent me a file to try and fix my truck. I went to my truck all was looking good till right at the end my ignition was on but I wasn't trying to start it and my truck just started turning over. So I quick shut the ignition off and it kept turning over for a couple seconds enough that I was able to jump out of the truck to run for a wrench to unhook the battery. So I called edge again they sent me a new file so they can read my programmer to see what's wrong. Now they are reviewing the file and will get back to me when they know something. 🙏
I Had an issue where the edge basically ate my stock calibration. So edge had to send me a new edge with a new stock calibration.
You could try to repair the device, then have them upload a new stock calibration and try again. But the truck starting on its own is just too weird.. Either way I would run the repair sequence before you upload a new file. Uploading the file will wipe the memory. If it happens again, get a new edge for sure..
Make sure your cig lighter fuse is perfect, and keep all accessories off and doors closed on the next try.
Did you see engine fail safe mode flash at you in on the message center?
This is another big reason why I'm happy I'm tuning with sct now. The edge CS and CTS units are very finicky and frankly not very robust.. I went through 3 edge CS units with black screens, bad capacitors and beeping before I finally got a good one.. Now I just use it as a gauge monitor..
Last edited by Especial86; 09-16-2015 at 10:46 AM.
#12
I did not see engine fail safe mode flash on the screen but the truck should be fixed by the end of this week with the help of the 1300 dollar new PCM. Now I don't know what to do with my edge cs I asked edge and they said no it's good it's all your truck but I don't want to sell it to someone and them go through the same thing I just did. I don't need it cause I'm planning on a 6.7 in my very near future. That was the whole reason of removing it.
The following users liked this post:
Toshbar (09-27-2015)
#15
Timber Baron
I imagine that the dealership programs the ECM/PCM before it is installed, if it is not already at time of arrival to the dealership.
#17
Senior Member
iTrader: (1)
No start after edge
Originally Posted by 07f350man
Yeah they had to order a new PCM from Ford direct and it was already programmed to my vin. There was an hour of labor total and the rest was all PCM. $1268
Glad it worked out either way you.. Sucks about the cost tho..