bonez

I'm looking for anyone that is running a 6" lift with MotoMetal 951 rims (20x10 with -18MM offset and 4.79" backspacing).

I was planning on getting the Rough Country 6" lift, but it says the max backspacing is 4.5", so my these rims have .29" backspacing for that lift. I don't know what the max wheel width is for this lift either.

I looked at the ProComp Stage 1 6" lift and it says the wheel width range is 8-9.5", so this wheel is .5" too wide.

Is there anyone running these rims with a 6" lift? If so, what lift are you running? Or does anyone know how to make either of these kits fits with these rims?

madeSICC

I have the same setup with the procomp stage 1. Check out my garage for pics. A little trimming was done to the fender wells.

bonez

Do you know the width, offset, and backspacing on your rims?