More Plastidip on my 04 FX4...
#1
Senior Member
Thread Starter
More Plastidip on my 04 FX4...
I Plastidipped the bottom of the doors/bed, the lower front grille, and both bumpers today, used a whole gallon of matte black, and only got 3 heavy coats out of it... Damn stuff goes quick! Came out pretty decent, although I did have one paint line I had to re-tape and re-spray because it wasn't wet enough when I pulled the tape off...
#2
I Plastidipped the bottom of the doors/bed, the lower front grille, and both bumpers today, used a whole gallon of matte black, and only got 3 heavy coats out of it... Damn stuff goes quick! Came out pretty decent, although I did have one paint line I had to re-tape and re-spray because it wasn't wet enough when I pulled the tape off...
#3
Senior Member
Thread Starter
Stuffs addicting. It did it to my truck and I was bout to trade it in. But changed my mind going to redo it after winter! Looks great by the way. I want those tires. In 34s.(they are expensive) But I got discoverer at3s right now that are almost brand new. Nice truck looks great.!!
#7
Senior Member
You do nice work.
Anybody ever try this with plasti dip?
Anybody ever try this with plasti dip?
Trending Topics
#8
Senior Member
#9
looks great. I want to do the same to my truck. Teach me please.
How long did it take?
How long until you recoat?
How long unit you peel the tape?
Did you use spray cans or brush on?
Thanks
How long did it take?
How long until you recoat?
How long unit you peel the tape?
Did you use spray cans or brush on?
Thanks
#10
Senior Member
Thread Starter
I used the DipYourCar sprayer system ( https://www.dipyourcar.com/dyc-dipsprayer.html ), But spray cans work fine if you are careful to coat evenly and warm the cans in warm water beforehand. (unless you're in a hot part of the country...
15-20 minutes between coats, and MAKE SURE if you have a lot of tape lines, to do the last coat in sections and make it a thick coat. wait about 30 seconds, then pull the tape. If you wait too long it will dry and pull your edge with the tape. If you don't wait long enough, the coats underneath will not have the time to re-liquify, so you'll pull them off as well...
I would say wait at least an hour before you drive the vehicle, and if possible let it sit and cure overnight...