gill88t

is it possible to just replace the bushing or do I have to replace the whole control arm. the unit looks like its all one piece.

VTX1800N1

Would also like to know..

60DRB

Are you talking about the ball joint nearer the wheel or the two "hinge" bushings? I've seen a couple u-tube videos on pressing out and replacing the ball joint. The two hinge bushings are replacable, but I haven't seen/heard of any good "how tos". Most of what I read says they can be pressed out, but not many folks have good things to say about doing that. The parts seem to often "corrosion weld" in place.

VTX1800N1

The bushings, not the ball joint. All of my suspension parts seem to be serviceable, but I am getting some inner front tire wear. Moog ball joints are inexpensive and I figured I would replace the bushings at the same time, but have not been able to find a source yet.

maxpat82

Rockauto have them.
they are just pressed in.

racecrew25

expect to pay a ton to have them pressed out....NOBODY likes to do it....HUGE p.i.t.a.....most of the time it's cheaper and easier to just get new arms.....just my .02